Xevious (again )

Body pop

Active member
vacBacker
Feedback
24 (100%)
Credits
1,266CR
Xevious dedicated again .So I've just changed the fuse holder and big
Blue ,thanks to nad equites for these
The rectifier has been changed
Board repaired and monitor chassis rebuilt
It's blowing the f2 fuse ,the original fuse holder and connector looked very brown /burnt
Any idea what would cause this ?
Has anyone got a decent photo of the inside of the power brick
To make sure I've put the rectifier in right
Thanks
 

RGP

Meeter & Greeter
Feedback
5 (100%)
Credits
2,039CR
I don't have one to hand but that would be consistent if you've fitted the bridge rectifier the wrong way around.

You'll have two pins marked with ~ (the tilde squiggle sign) a + and a -.

The AC input goes across the ~ either way around then you need to get your DC output right.

I think the cap is straight across the output but without a scheme in front of me I can't tell you.
 

Body pop

Active member
vacBacker
Feedback
24 (100%)
Credits
1,266CR
Thanks James ,your a wealth of knowledge
Bet that is what's happened
I put the rectifier in a few weeks ago ,and remember thinking .now what way does this go
I think it just has the squiggle and plus marking on one side Body pop2016-08-14 16:45:12
 

Body pop

Active member
vacBacker
Feedback
24 (100%)
Credits
1,266CR
I think I have it right now
So it's ,+ from big blue to + on rectifier
- from big blue to - on rectifier (opposite corner to the plus)
Then the other two. Just on opposite corners

It's still blowing that fuse ,though f2 I don't have any slow blow left though now
I do have neck glow on monitor again ,that I had lost
 

Body pop

Active member
vacBacker
Feedback
24 (100%)
Credits
1,266CR


Fuse no longer blowing,flyback brightness turned up ,screen looks like this
The xevious bit on screen is screen burn
Any ideas anyone ,what the issue could be ?
 

obcd

Active member
Credits
3,830CR
Your monitor is not getting any video signal from the game board. The monitor itself might (or might not) work. You will need to lower the screen voltage again till you have a black screen.
 

Body pop

Active member
vacBacker
Feedback
24 (100%)
Credits
1,266CR
Thanks obcd .
When I turn it down to black there is only a very /hardly visable blue line at bottom of screen
It's not play playing blind
Monitor was repaired /new flyback etc
Board was repaired
Power brick rebuilt (by myself just )
 
Top