Atari Volcano buttons

shrunkenmaster

Active member
vacBacker
Feedback
2 (100%)
Credits
162CR
Anyone know what voltage these run at, and how to wire them up correctly to avoid blowing the lamps?

Thanks in advance, you wonderful lot
smiley4.gif
 

Purity

The Oracle
vacBacker
Feedback
17 (100%)
Credits
2,999CR
They operate at 2v max. I believe they utilise 5v but have some inline resistors to reduce the voltage. So with my Asteroids I believe they have the inline resistors on the PCB.

If you ran them directly at 5v you would kill them
Purity2014-05-01 22:33:44
 

Purity

The Oracle
vacBacker
Feedback
17 (100%)
Credits
2,999CR
Regards wiring I think you have COM (Common), NO (normally open) and NC (normally closed)

Your start button would be wired to COM and NO.

Then you would have connections to +2v and gnd to power the LED

I can check my Atari Asteroids wiring to be 100% certain on this, if that would help?
 

bomjac

Active member
Feedback
3 (100%)
Credits
453CR
Point to note - if you wire them up and they do not light when coined - it could be you have your +v and zero line crossed. There should be no danger to the LED by reverse connection, so swap them around and it may cure your problem.

These operate in current drain mode - so there should be +5V on the anode at all times. They light up by the pcb providing a current path when credited. Cant see the limiting resistors on the schematice, but generally 330 or 470 ohms is about right.

Edit - p3 of the following pdf shows the package connections for the cones. Interesting that Atari used inductors in line for all their player input connections.

http://www.classicgaming.cc/classics/asteroids/tech/asteroids_drawingpackagesup.pdf

bomjac2014-05-02 06:56:00
 
Top