Woohoo! Good news everyone...... On Saturday, an amazing friend (u72) came over on bearing a gift of a loan of a Battlezone PCB set.
So my BZ cab is now up and running while its original board is off being fixed.
However, the display is not vertically in the correct place and I am stuck on how to move it down. There are solder points on the PCB for X and Y centering BUT the manual doesn't list them as being present so it looks like that section of the board was generic.
Is there a control to adjust on the monitor, I would have thought so but I can't see one looking at it from the back.
We've taken Y-SIZE and X-SIZE in as much as possible to get an almost playable game but you can tell there's bits hidden in the cardboard bezel area.
Thanks
So my BZ cab is now up and running while its original board is off being fixed.
However, the display is not vertically in the correct place and I am stuck on how to move it down. There are solder points on the PCB for X and Y centering BUT the manual doesn't list them as being present so it looks like that section of the board was generic.
Is there a control to adjust on the monitor, I would have thought so but I can't see one looking at it from the back.
We've taken Y-SIZE and X-SIZE in as much as possible to get an almost playable game but you can tell there's bits hidden in the cardboard bezel area.
Thanks