strykr said:its pretty thick to get through with a craft knife I think. But might try that, Tony i'll invoice you when i shag it up.![]()
Im not sure I can get a nice clean line with a hacksaw but these are definitely options to explore! my concerns are cracking/melting it, if i get power tools involved. Has anyone tried these methods?
muddymusic said:Tony's method is what I was going to suggest also. Far less likely to get cracking, just make sure it's properly supported from underneath. I've tried doing one with a saw and it cracked in 2 places when the blade got stuck a little - although that could be down to me/or the blade!
Hurray Banana said:At the end of the day it's probably a sh*t or bust job cutting this by whatever method.
vib_ribbon said:would it be easier if you softened it up a bit in the oven first?
strykr said:thanks for your suggestions fellers, seems its a bit of a gamble no matter what method! I have no router table etc, so I'm down to knife or hacksaw, I think it may just be a case of clamping and a LOT of scoring with a knife!
big10p said:That's an idea I haven't tried. I use a paint stripper heat gun for bending plain perspex - works a treat. Wouldn't go near a painted marquee with it, though!
If scoring with a knife, I'd cut from both sides. It would probably snap apart pretty cleanly, once you've cut most of the way through.
Hurray Banana said:strykr said:thanks for your suggestions fellers, seems its a bit of a gamble no matter what method! I have no router table etc, so I'm down to knife or hacksaw, I think it may just be a case of clamping and a LOT of scoring with a knife!
I think you should do a video when you do finally attempt this Rich so we can see how fraught or not a process this turned out to be