The saga continues...
I'm now running the game from a different power supply. No more shocks from any exposed wiring.
Game is dead. Monitor shows a static image of multicoloured squares.
- Checked all voltages on the regulator board. All voltages present and OK. +5V is a little low at 4.95V - adjusted it up to +5V after finding the pot covered with gel - no change.
- Checked voltages on game board - +5V OK. LED lit.
- Decided to check pins on the CPU. RESET* and HALT* are low. Trace back on schematics. SYSRES* is low.
- Strap the watchdog circuit. No change - RESET* is high but HALT* is low.
- Check 7407 at 13K. SYSRES* is at 4.20V at pin 11 and the output is 0.3V.
- So... bad 7404. (I think!)
And this is where I attempt to solder something for the first time in decades. And have made a mess of it.
I followed the tips in this video (
http://www.youtube.com/watch?v=3XeEn2ENYj0). Added new solder to existing 7407 pins on solder side of board - and used at 18W iron with chisel tip and solder-sucker to remove solder. This takes about half an hour but in the end I get the solder out.
7407 is still solid in the PCB. Attempt to remove solder from component side using braid. Only a little is removed.
Attempt to add more solder to the solder side of the board and suck it out again. Only succeeded in refilling some of the holes which are now being very stubborn.
Find an old 50W solder station with pointed tip. Decide that it's probably too powerful. I've now spent 90 minutes trying to remove that 7407.
So, there must be an easier and quicker way to do this?
As for the 7407, I'm thinking of sawing through the legs with a Dremel, melting the solder on the component side and using pliers to remove the rest of the legs. Would this work?
All the best,
Simon