Hello,
A while ago I was doing some board repairs, and a bunch of you gave me some feedback on improving my desoldering techniques. They helped at the time.
However, I want to make desoldering easier still. Right now I'm working on Sega multi-layer PCBs with enormous ground planes. These are difficult to desolder from. I was chatting to Mark from Retroclinic and he mentioned he had to pretty much use an iron at 450c for 10-20 seconds to loosen a pin.
In my case, I struggle further. Sometimes it takes about 20 mins to loosen a ground pin (re-solder/suck solder/try again). This clearly is ridiculous and not a practical use of time - plus I worry that I'll damage a board by spending so long messing about with a single pin. I need a faster way of working on these boards and would welcome advice. I'm pretty sure it's not my technique, but actually my tools as I can easily desolder from simpler PCBs and pins that don't carry ground or power even on a multi-layer board.
Right now my setup is basic:
60W Soldering Iron:
http://www.maplin.co.uk/p/60w-mains-lcd-solder-station-a55kj
Actually a nice iron for basic tasks in my opinion. Would more wattage help or a better quality brand?
Duratool Desoldering Station
Should I just bite the bullet and upgrade to a Hakko? I've been tempted, but I need to be sure this will really make a difference before spending £250.
I've also tried good quality braid, the application of flux, a decent hand pump etc. The thickness of the board and the number of layers just mean it's difficult to fully clear the hole.
Thanks!
A while ago I was doing some board repairs, and a bunch of you gave me some feedback on improving my desoldering techniques. They helped at the time.
However, I want to make desoldering easier still. Right now I'm working on Sega multi-layer PCBs with enormous ground planes. These are difficult to desolder from. I was chatting to Mark from Retroclinic and he mentioned he had to pretty much use an iron at 450c for 10-20 seconds to loosen a pin.
In my case, I struggle further. Sometimes it takes about 20 mins to loosen a ground pin (re-solder/suck solder/try again). This clearly is ridiculous and not a practical use of time - plus I worry that I'll damage a board by spending so long messing about with a single pin. I need a faster way of working on these boards and would welcome advice. I'm pretty sure it's not my technique, but actually my tools as I can easily desolder from simpler PCBs and pins that don't carry ground or power even on a multi-layer board.
Right now my setup is basic:
60W Soldering Iron:
http://www.maplin.co.uk/p/60w-mains-lcd-solder-station-a55kj
Actually a nice iron for basic tasks in my opinion. Would more wattage help or a better quality brand?
Duratool Desoldering Station
Should I just bite the bullet and upgrade to a Hakko? I've been tempted, but I need to be sure this will really make a difference before spending £250.
I've also tried good quality braid, the application of flux, a decent hand pump etc. The thickness of the board and the number of layers just mean it's difficult to fully clear the hole.
Thanks!