OK, So i sent some test files for and it appears that the micro-controller is stuck in reset display mode, maybe from a stuck pin on one of the logic pins.
The 93c46 keeps getting overwritten in Bytes 00 to 95 with the pure ASCII printable codes (32-127, Hex codes 20 to 7F), which I suspect is the factory default message showing what the DMD can be programmed with.
Bytes 96-127 appear to be unused and ignored by the DMD and the micro-controller. There were characters (B and K) in Bytes 96-97 of the original file, however these appear to be just left over from the previous message (and tested with random codes in bytes 96-127).
I would suggest next steps are either to test (or just replace) the logic chips and as there are only a few other components may as well do those at same time. If that doesn't work then to attempt to read the APROM of the Micro-controller in ISP mode.
simonden2016-06-27 14:18:54
The 93c46 keeps getting overwritten in Bytes 00 to 95 with the pure ASCII printable codes (32-127, Hex codes 20 to 7F), which I suspect is the factory default message showing what the DMD can be programmed with.
Bytes 96-127 appear to be unused and ignored by the DMD and the micro-controller. There were characters (B and K) in Bytes 96-97 of the original file, however these appear to be just left over from the previous message (and tested with random codes in bytes 96-127).
I would suggest next steps are either to test (or just replace) the logic chips and as there are only a few other components may as well do those at same time. If that doesn't work then to attempt to read the APROM of the Micro-controller in ISP mode.
simonden2016-06-27 14:18:54