Hey Guys
I've not seen that particular kind of problem with GORF per se, I have two possibilities here:
1) Bad grounding on the monitor neck to the tube or other similar monitor issue.
2) RGB board is picking up interference.
3) Could be your pattern board - this can sometimes generate snow BUT usually it is within the virtual border of the game playfield on the screen.
GORF is an awesome game and well worth preserving. Its a game that plays absolutely terrible in MAME and 15 years on they've never fixed the emulation issues that are noted.
One day i'll make an FPGA (like JROK) version of the astrocade system and we'll all be able to play GORF forever.....
Anyway, how to resolve your problems.
1) Switch off, wrap up neatly and ship to me for safe keeping ....
just kidding!
I believe you can indeed take the outputs from the loom and hook them up to component video inputs on something like a VCR or other SCART device via a suitable converter - don't get into the complexities of making a scart cable up.
GORF uses YPbPr (Yipper) output or in Midway speak R-Y, B-Y, Y+SYNC.
R-Y pin = Pr
B-Y pin = Pb
Y pin = Y
If you're interested at all in the video encoding then wikipedia has a good article
here
Remember to ground all three cables if using phono's.
This would eliminate the RGB board or confirm its the source of the problem.
If you don't have time for any of this, you can send me your PCB stack and RGB converter and I can put them on my test loom.
I can fit you a heat sink at the same time, I don't list these on my store yet because I haven't found a good constant supplier for them plus you need a decent tube of thermal bonding compound as well and I can only ever find large tubes - that artic grey stuff for PC's is no good for these type of chips.
Please don't run your game for too long without a heat sink on the data custom chip (the one in the middle of the CPU board - U15 sounds right, I haven't got a set near me).
The address chip (U3) almost never goes bad, its the data chip - for whatever idiotic design reason they chose to put two voltage regulators in it - a 2.5vDC and a 7.5vDC - the input voltage to the chip is 5v so a lot of heat is made the chip which unless dissipated properly will just kill it. Probably the same kind of design thinking that says lets use composite video instead of RGB like everyone else does.
Nobody's cracked this custom chip yet, I keep pestering one or two known chip-crackers to work with me on this - up until recently, ATARI's Slapstick chip was also a huge problem so we shall see on this one.