Ok so I bought a BAS Jamma cab about a month back and I've replaced all of the harness as it was missing solder points for buttons 4, 5 and 6 and it was badly soldered and hacked a bit.
The Hantarex US 250 power supply was outputting 4.75 on the 5v, -3.3 on the -5 rail and about 10.5 on the 12 volt rail (under load), so I thought best change the PSU (even though it boots games and runs fine)
I've put in a brand new MWP-606 from ArcadeWorldUK and the voltages are now spot on, however having spoking with my Dad (who was a television engineer for 30 years), hes told me that the original power supply (if repaired and recapped) is less likely to kill my PCB if parts of it fail as if parts of it fail, as voltages will just go down. A switch mode powersupply (if parts fail) would give a high voltage output which will most likely kill the PCB.
So I'm stuck in a dilemma. Do I repair the original Hantarex US 250 PSU by recapping and use that (still with mostly 30 year old components) or do I continue to use the new MWP-606 switch mode power supply that's brand new? At the end of the day, I want to try and protect me valuable, irreplaceable PCBs!
What do you guys generally do? Recap the original PSU or change to a new switch mode PSU?
Thanks in advance!
The Hantarex US 250 power supply was outputting 4.75 on the 5v, -3.3 on the -5 rail and about 10.5 on the 12 volt rail (under load), so I thought best change the PSU (even though it boots games and runs fine)
I've put in a brand new MWP-606 from ArcadeWorldUK and the voltages are now spot on, however having spoking with my Dad (who was a television engineer for 30 years), hes told me that the original power supply (if repaired and recapped) is less likely to kill my PCB if parts of it fail as if parts of it fail, as voltages will just go down. A switch mode powersupply (if parts fail) would give a high voltage output which will most likely kill the PCB.
So I'm stuck in a dilemma. Do I repair the original Hantarex US 250 PSU by recapping and use that (still with mostly 30 year old components) or do I continue to use the new MWP-606 switch mode power supply that's brand new? At the end of the day, I want to try and protect me valuable, irreplaceable PCBs!
What do you guys generally do? Recap the original PSU or change to a new switch mode PSU?
Thanks in advance!