Calling all monitor gurus!
I am swapping over a brn free tube with a slightly burnt one on my Dig Dug Euro.
Problem is, now I have them all in bits ready to swap - the old tube has 1 les pin on the neck socket!
The chassis is a good 'ol G07 with a Hitachi tube 51OUJB22 with 9 pins + 1 pin
The new tube is a Rauland 19VNJP22 which only has 8 pins + 1 pin
I was sold this as a straight swap, and I think it is, as the G07 neck board doesn't have the offending extra pin wired up?
I really need some advice before doing this!!
Another quick tutorial on checking the yoke wires too would be helpful (I forgot
)
I am swapping over a brn free tube with a slightly burnt one on my Dig Dug Euro.
Problem is, now I have them all in bits ready to swap - the old tube has 1 les pin on the neck socket!
The chassis is a good 'ol G07 with a Hitachi tube 51OUJB22 with 9 pins + 1 pin
The new tube is a Rauland 19VNJP22 which only has 8 pins + 1 pin
I was sold this as a straight swap, and I think it is, as the G07 neck board doesn't have the offending extra pin wired up?
I really need some advice before doing this!!
Another quick tutorial on checking the yoke wires too would be helpful (I forgot