Ongoing saga; asteroids PCB's

grobda

"Look at the size of that thing!"
vacBacker
Feedback
7 (100%)
Credits
1,061CR
Currently working on an asteroids PCB. using a scope as test display.

work so far;

Replaced missing x/y adjust pots. Burned replacement vector rom, tested CPU, tested roms.

Replaced missing 12Mhz xtal @A5

Plugged in, watchdog barking, disabled watchdog. Cpu ran a short while then crashed. scoped program rams at D2/E2 looked shaky. Replaced and CPU runs.

Lifted Pin1 of 74ls42@L6 as mentioned on ionpool.net guide and put in test mode. scoped audio pin and was giving hi hi lo signal. replaced RAM at M4 and gave hi hi hi lo signal. decided to replace all remaining RAM to get off this particular merry go round.

Game then played blind. Reconnected scope as display and on start-up got a display for a moment and then screen collapsed. swapped out the 4016s in the output section and got a picture for a while with issues;

nkcy.jpg


test image is visible all the time over gameplay.

screen then collapsed again and reverted to collapsing after being briefly visible;

[tube]http://www.youtube.com/watch?v=FeSzfeh-tP0[/tube]

swapped out 4016s again, no change

and that's where i'm at, any ideas on whats causing the screen collapse? test rig works fine with working board.

grobda2013-09-12 00:17:18
 

grobda

"Look at the size of that thing!"
vacBacker
Feedback
7 (100%)
Credits
1,061CR
decided to investigate power input as guessing that could cause the xy to fail, especially after being momentarily visible IE cap charging, and the game playing blind.

noticed 7915 voltage regulator was v hot, measured dc input was -41v, outside of spec for part according to TI datasheet, compared with working pcb which was at 35v. checked input of other voltage regulators was 8.2v (supposed to be 22v) thus board getting max 8.2v output from the 15v snd 12v regulators.

noticed c86 was slighly swollen so replaced c86 and c87, the two main smoothing caps for the rectifier. fault persists... I can only look to the 4 x 4001 diodes that make up the rectifier.

a3wf.png


or am I barking up the wrong tree completely?

grobda2013-09-03 22:16:18
 

PaulSwan

ZZZ
Feedback
1 (100%)
Credits
1,118CR
I'd check the diodes as you say and that C84 or C85 were not short to GND. Its looks like using 2-phase full wave rectification. From the diagram, there is no common reference - for this to work, you'd need the GND reference at the 0VAC point but it might be via the transformer center tap.

The bad cap might be a symptom of the overvoltage. The diodes are easy to check.
Good luck,
Paul.
 
Feedback
1 (100%)
Credits
78CR
Shouldn't be -41v to ground on one of the regulators? The input is 36vac across a ground, so 18-0-18. Each input to the regs should be +/-22v ish - is your Power supply (or AR2) giving the correct AC input?

Mark.
 

grobda

"Look at the size of that thing!"
vacBacker
Feedback
7 (100%)
Credits
1,061CR
Turns out using a jamma brick to supply the 5v is a bad idea. Fixed a borrowed AR2 and the picture is back. Game now goes into attract mode with test graphics superimposed and crashes when coined up. Plays blind OK.

More fun tomorrow :)
 

grobda

"Look at the size of that thing!"
vacBacker
Feedback
7 (100%)
Credits
1,061CR
test mode / crash on coinup both caused by a bad 74193 counter at J5. PCB now works but has a bad dac which i knew was duff

the good one i robbed from this pcb is in the meteoroid cab.
smiley36.gif
 

grobda

"Look at the size of that thing!"
vacBacker
Feedback
7 (100%)
Credits
1,061CR
Couple more asteroids faults fixed;

Bad Vector RAMS; self test doesn't always give the correct beep code, check those that are paired.... or just replace them all TBH - thieyve all been fried on 3 pcbs so far.

Y signal collapse - DAC@B11 was active, associated 4016@B12 was dead, piggybacking a good chip worked.

Constant beeping in self test - bad 74ls157@H3, piggybacking didn't work.

Shot sound is a faint click - bad LM324 op-amp at L8. piggybacking worked.
 

grobda

"Look at the size of that thing!"
vacBacker
Feedback
7 (100%)
Credits
1,061CR
Got VSG running on another, plays OK but vectors are messed up;

Test mode;

x4m0.jpg


Game;

oxuv.jpg


looks like klingon
smiley36.gif


thinking x-position counter fault at the moment.

grobda2013-09-12 00:29:24
 
Top