Currently working on an asteroids PCB. using a scope as test display.
work so far;
Replaced missing x/y adjust pots. Burned replacement vector rom, tested CPU, tested roms.
Replaced missing 12Mhz xtal @A5
Plugged in, watchdog barking, disabled watchdog. Cpu ran a short while then crashed. scoped program rams at D2/E2 looked shaky. Replaced and CPU runs.
Lifted Pin1 of 74ls42@L6 as mentioned on ionpool.net guide and put in test mode. scoped audio pin and was giving hi hi lo signal. replaced RAM at M4 and gave hi hi hi lo signal. decided to replace all remaining RAM to get off this particular merry go round.
Game then played blind. Reconnected scope as display and on start-up got a display for a moment and then screen collapsed. swapped out the 4016s in the output section and got a picture for a while with issues;
test image is visible all the time over gameplay.
screen then collapsed again and reverted to collapsing after being briefly visible;
[tube]http://www.youtube.com/watch?v=FeSzfeh-tP0[/tube]
swapped out 4016s again, no change
and that's where i'm at, any ideas on whats causing the screen collapse? test rig works fine with working board.
grobda2013-09-12 00:17:18
work so far;
Replaced missing x/y adjust pots. Burned replacement vector rom, tested CPU, tested roms.
Replaced missing 12Mhz xtal @A5
Plugged in, watchdog barking, disabled watchdog. Cpu ran a short while then crashed. scoped program rams at D2/E2 looked shaky. Replaced and CPU runs.
Lifted Pin1 of 74ls42@L6 as mentioned on ionpool.net guide and put in test mode. scoped audio pin and was giving hi hi lo signal. replaced RAM at M4 and gave hi hi hi lo signal. decided to replace all remaining RAM to get off this particular merry go round.
Game then played blind. Reconnected scope as display and on start-up got a display for a moment and then screen collapsed. swapped out the 4016s in the output section and got a picture for a while with issues;
test image is visible all the time over gameplay.
screen then collapsed again and reverted to collapsing after being briefly visible;
[tube]http://www.youtube.com/watch?v=FeSzfeh-tP0[/tube]
swapped out 4016s again, no change
and that's where i'm at, any ideas on whats causing the screen collapse? test rig works fine with working board.
grobda2013-09-12 00:17:18