Outrun ic question

Mykill

Active member
Feedback
1 (100%)
Credits
229CR
I brought some tmm2063p-10 SRAMs but was sent tmm2063p-15 the last number represents max access time in n/s will it be alright to use these instead ,as I read it the last number represents maximum speed it could handle
 

dj_yt

Active member
Feedback
3 (100%)
Credits
787CR
Hmm, not sure. I'd socket them and try. From memory, OutRun PCBs have 100ns SRAM for the most part. But perhaps you'll get away with slower SRAMs.

FWIW, I usually avoid purchasing old SRAMs when doing repairs. For starters, they are likely to fail if they are ancient. Secondly, modern equivalents are usually much faster so you won't have to worry about access time issues.
 

karlcdoe

Active member
vacBacker
Feedback
8 (100%)
Credits
887CR
as the main man says you could try them, and see if it glitches its way to victory.

FWIW if you get more try and get something close to the same speed rather than super fast alternatives, as some old boards won't run them due to various timing issues/bus noise (insert worldly sounding reason here). No idea how fussy Out Run is though...
karlcdoe2018-02-16 14:39:00
 

philmurr

Active member
vacBacker
Feedback
48 (100%)
Credits
2,374CR
dj_yt said:
Secondly, modern equivalents are usually much faster so you won't have to worry about access time issues.

...usually the case. But there are games out there that rely on slow memory, and the faster modern memory can sometimes cause issues.
 

dj_yt

Active member
Feedback
3 (100%)
Credits
787CR
philmurr said:
...usually the case. But there are games out there that rely on slow memory, and the faster modern memory can sometimes cause issues.

Good to know. I've not encountered this myself yet thankfully...

dj_yt2018-02-16 15:50:48
 
Top