Yes, just a single wire simply because I run it through a cab on/off switch, which then splits off to power the individual 12v components. Pretty sure the wire doesn't get hot, but I'll meter the current draw when I've replaced the relay (bought a genuine OMRON from RS - the difference is build quality is obvious). I may replace the 12v wire to the switch with a bigger gauge, if necessary. So, I can simply tie several of the 12v wires together if I need more current? I wasn't sure as inside the PSU, the 12v wires seem to be attached to different points on the PCB.
Some of the fake stuff out there is shocking. As you say, they don't seem to care about safety, just profit.
Thanks for the offer to look things over. I hope to get back to the cab soon - fit the new relay etc. - and will be in touch when it's done, if that's OK.
Cheers, Dave!