Hi all, I have a polo 1 20" monitor with a wobbly picture down either side.
I had the same problem with 25" polo 2 and Craig at giz10p kindly have me some tips to help solve it.
These are lists below.
Steve, C18 is the feedback for the SMPSU, if this cap is bad you will get no end of issues as the output from the PSU's secondary will be all over the place.
FTW: Id always replace C18 22uf 50v, c25 22uf 50c and C17 220uf 50v on any polo chassis repair regardless. C18 will cause anything from shutdown, wobbles and even blow the HOT depending on how bad it is. C18 is located at the back of the heat sink of the PSU cage, the other two are around the SMPSU IC1.
Id replace those 3 caps, and test the rest of the caps in secondary of the PSU which are all on the back edge of the PSU cage, I wont go through the location numbers as they differ with versions of the Polo chassis.
The question is I can't find the same locations on a polo1 20".
Can someone point me in the right direction with cap locations so I can try the same fix on my polo 1 20".
Could it be the same fix for this monitor?
The picture is nice and bright just not stable down each third of the screen.
I have tried it in another cab and it is still the same.
Cheers,
SteveSteve2014-08-09 10:36:57
I had the same problem with 25" polo 2 and Craig at giz10p kindly have me some tips to help solve it.
These are lists below.
Steve, C18 is the feedback for the SMPSU, if this cap is bad you will get no end of issues as the output from the PSU's secondary will be all over the place.
FTW: Id always replace C18 22uf 50v, c25 22uf 50c and C17 220uf 50v on any polo chassis repair regardless. C18 will cause anything from shutdown, wobbles and even blow the HOT depending on how bad it is. C18 is located at the back of the heat sink of the PSU cage, the other two are around the SMPSU IC1.
Id replace those 3 caps, and test the rest of the caps in secondary of the PSU which are all on the back edge of the PSU cage, I wont go through the location numbers as they differ with versions of the Polo chassis.
The question is I can't find the same locations on a polo1 20".
Can someone point me in the right direction with cap locations so I can try the same fix on my polo 1 20".
Could it be the same fix for this monitor?
The picture is nice and bright just not stable down each third of the screen.
I have tried it in another cab and it is still the same.
Cheers,
SteveSteve2014-08-09 10:36:57