I wonder if a filament kathode short could cause such an issue?
In that case, the only thing that can be done is isolating the filament and driving it from a winding around the lopt, or a separate 6.3V voltage source.
I have done such myself.
We had such short once, but it killed the filament, so the tube is scrap.
I read it's sometimes possible to remove such a short by discharging a capacitor between the 2 shorted pins. Again, never done this myself.
It looks like the short is only there when the filament is heating the tube. So, you might need a 6.3V power source to drive the filament anyhow.
Maybe gunblade can comment on this? He sounds even more experienced than I am.
In that case, the only thing that can be done is isolating the filament and driving it from a winding around the lopt, or a separate 6.3V voltage source.
I have done such myself.
We had such short once, but it killed the filament, so the tube is scrap.
I read it's sometimes possible to remove such a short by discharging a capacitor between the 2 shorted pins. Again, never done this myself.
It looks like the short is only there when the filament is heating the tube. So, you might need a 6.3V power source to drive the filament anyhow.
Maybe gunblade can comment on this? He sounds even more experienced than I am.