Polo 2 problems

obcd

Active member
Credits
3,830CR
I wonder if a filament kathode short could cause such an issue?

In that case, the only thing that can be done is isolating the filament and driving it from a winding around the lopt, or a separate 6.3V voltage source.

I have done such myself.

We had such short once, but it killed the filament, so the tube is scrap.

I read it's sometimes possible to remove such a short by discharging a capacitor between the 2 shorted pins. Again, never done this myself.

It looks like the short is only there when the filament is heating the tube. So, you might need a 6.3V power source to drive the filament anyhow.

Maybe gunblade can comment on this? He sounds even more experienced than I am.
 

pulstar

Active member
Feedback
41 (100%)
Credits
459CR
Well, just swapped the drive transistors around (T2 to T4) - no difference on the flood of green (the few seconds at the beginning when the picture is normal shows green now, though, like it should). B+ measured at a steady +115v through the normal image and the green flooded image.

It's looking more and more likely that this is a tube fault.
 

obcd

Active member
Credits
3,830CR
In my case, it started with an all red picture. As it was only the left monitor of a f355 deluxe, we left it running like that for a couple of days assuming it was one of the drive transistors. When I finally had time to check it out, all red was gone. Switching the chassis confirmed that it was the picture tube at fault. As I wrote before, sometimes a short can be burned away, but I have no details how to do this. You will need to figure out first which 2 electrodes of the tube have a short.

In our case, the picture was all red, but the flyback lines weren't all that visible if I remember well.
 

pulstar

Active member
Feedback
41 (100%)
Credits
459CR
Little update. I left the machine on today and have noticed that occasionally the screen goes back to normal for a at most two minutes then goes back to full green. I noticed if I leave it one for a while (say 30 minutes) then turn it off and back on again, the green stays away for longer, probably about a minutes worth of normal display.
 

pulstar

Active member
Feedback
41 (100%)
Credits
459CR
That'll be good. Thanks. I'll PM you
smiley1.gif

pulstar2014-10-14 17:42:54
 

tb2000

Active member
Feedback
4 (100%)
Credits
3,578CR
I'd say that by the sounds of it it's got a chassis fault rather than a tube fault. I'd have been surprised if it was the tube at fault as in my experience the tubes which seem to be more likely to have problems are American WG ones (particularly Zenith ones) and Japanese ones (like Sanwa tubes). I've very rarely seen a Hanty tube go wrong, although I did have an old Videocolor A51-427X (usually came with the 900/E) a few years ago which had almost no green, but that was fixed with a rejuvenation.
smiley1.gif
 

pulstar

Active member
Feedback
41 (100%)
Credits
459CR
A quick update of this thread.

I sent the chassis to Gunblade to test for me and it was working perfectly. I'd given up hope and assumed it was now a tube problem but Gunblade had an idea. My particular tube required a 12ohm resistor on the neck whereas most others are fine with the 2 12ohm resistors running in parallel that was on the Polo2 chassis. He removed one and sent it back and now it works perfectly.

Thanks for everyone who offered suggestions in this thread, and thanks to Gunblade for working out what the particular problem was and offering to test my chassis for me.
smiley20.gif
 
Top