Hi,
I'm hoping someone might be able to help me with this problem please.
I have got an old Jamma cab that is running a PSU called a "Hantarex switched mode power supply US250". It has always run my current two PCB boards (Double Dragon 1&2) no problems. Recently I bought an R-Type bootlet PCB and although it runs, there are a few small problems (such as the background doesn't appear when you are playing the game and hence, you crash your ship all of the time by running into things you can't see).
It has been suggested to me that a bootleg PCB requires slightly more voltage, say 5.1 or 5.2v.
I'm finally getting to the question now: My power supply has an adjustment on the top but it is already set to max and won't go any further and is only kicking out 4.9v.
Should it be possible to adjust it up a bit more?
Does anyone have experience of a bootleg pcb requiring more voltage to run?
Does the fault I described with R-Type seem likely to be a voltage issue?
Thanks in advance for any advice!
Woodstock
I'm hoping someone might be able to help me with this problem please.
I have got an old Jamma cab that is running a PSU called a "Hantarex switched mode power supply US250". It has always run my current two PCB boards (Double Dragon 1&2) no problems. Recently I bought an R-Type bootlet PCB and although it runs, there are a few small problems (such as the background doesn't appear when you are playing the game and hence, you crash your ship all of the time by running into things you can't see).
It has been suggested to me that a bootleg PCB requires slightly more voltage, say 5.1 or 5.2v.
I'm finally getting to the question now: My power supply has an adjustment on the top but it is already set to max and won't go any further and is only kicking out 4.9v.
Should it be possible to adjust it up a bit more?
Does anyone have experience of a bootleg pcb requiring more voltage to run?
Does the fault I described with R-Type seem likely to be a voltage issue?
Thanks in advance for any advice!
Woodstock