Hi,
My PSU was already wired with the "switch" in the configuration that was shown in the image above, so I went straight to testing the outputs. I suppose this is because my machine doesn't have an on/off switch, I just plug it in or unplug it.
I tested my output +5v supply as that is the only feed that is supplied by the PSU, the monitor is supplied by a transformer. I have put a picture in below as I'm not sure if this is a standard set up?
Anyway, i got the following results: I was able to turn the +5v up to 5.2v, which is what I need for the bootleg PCB and when I measure at the output from the PSU, that is what I get, 5.2v. However, when I plug in the PSU and test the voltage on the CPU (on one of the corner legs of a chip), it has dropped to 4.6v, does this sound right?
Also, you will note below that the monitor is supplied directly from the transformer in the bottom left corner of the picture. I have measured the voltage that is going up to the monitor and it is 104v.
Should have said, the game still doesn't work as it should. A lot of vertical lines on the monitor that obscure the picture and "hidden" background that you crash your ship into because you can't see it.
Thanks for any pointers! BTW, just to reiterate, my double dragon 1&2 PCB's work fine.