Have an R-Type board set that died last October and i've finally got around to being confident to have a look at it.
I have been fortunate enough to borrow another board that does work to single out the offending layer - its the CPU (M72-A-C) board.
I have clock, reset etc that you'd expect.
The primary problem seems to be with the latches on the CPU address/data bus.
There's a signal called BUS CHANGE which controls the 373's and some 244's directions. This is stuck low.
This is noted on the schematic as being pulled up by R19 and also connected to CN3-10B. Following the drawing back, CN3-10B on the ROM board does indeed have a designation for BUS CHANGE but its not apparently used.
It's not the ROM board as that works on the alternate set and the alternate set's ROM board doesn't boot the non-working set.
I'm stuck where I can't find the origin of BUS CHANGE.
My understanding is that it needs to change to HI in order for address lines to pass over the 373's onto the address busses.
I can see data at all the inputs of all the 373's but the outputs are held HI or floating with nothing going on on /OE (pin 1) at all.
Anyone able to help find the source of this signal as i'm sure that's the root problem as why the board isn't starting up.
Thanks.
I have been fortunate enough to borrow another board that does work to single out the offending layer - its the CPU (M72-A-C) board.
I have clock, reset etc that you'd expect.
The primary problem seems to be with the latches on the CPU address/data bus.
There's a signal called BUS CHANGE which controls the 373's and some 244's directions. This is stuck low.
This is noted on the schematic as being pulled up by R19 and also connected to CN3-10B. Following the drawing back, CN3-10B on the ROM board does indeed have a designation for BUS CHANGE but its not apparently used.
It's not the ROM board as that works on the alternate set and the alternate set's ROM board doesn't boot the non-working set.
I'm stuck where I can't find the origin of BUS CHANGE.
My understanding is that it needs to change to HI in order for address lines to pass over the 373's onto the address busses.
I can see data at all the inputs of all the 373's but the outputs are held HI or floating with nothing going on on /OE (pin 1) at all.
Anyone able to help find the source of this signal as i'm sure that's the root problem as why the board isn't starting up.
Thanks.