Sync Issues

Purity

The Oracle
vacBacker
Feedback
17 (100%)
Credits
2,999CR
Hope you can help?

I'm having sync issues with various boards, mostly Konami and Nintendo.

My setup is a Jamma edge connector wired straight to an arcade switcher, and the RGB is wired directly to a 9 pin D connector that plugs into a 1084S monitor. The monitor is in analogue mode so inputs are Red, Green, Blue, Ground and CSync.

Jamma boards on this look perfect, and I also tried a Universal PCB and this was fine. It's just other boards, like Konami and Nintendo I'm having issues with. I believe these have narrower syncs, and this is the problem?

There is a hold pot on the monitor but this doesn't really help much.

I was thinking of cutting into the sync line and adding a 5k pot and capacitor to help make the narrow syncs more acceptable on the monitor. Something like this (apologies for the crude drawing)

What do you guys think? Would this fix my issues?

Sync.jpg
 

Purity

The Oracle
vacBacker
Feedback
17 (100%)
Credits
2,999CR
It's all going via composite sync - which is a combination of both.

I've not idea whether the problem boards are causing a vertical or horizontal sync issue
 

guddler

Busting vectors like it's 1982!
vacBacker
Feedback
10 (100%)
Credits
4,058CR
1084S monitors can be a pain in the arse to be honest. I had one for a while and what I did was open it up and inside I found that there was a sync pot on the PCB that wasn't exposed to the outside world. I forget which sync it was, but I used wires to extend it to the outside of the monitor.

I also found another pot shown on the schematics what was not populated in my variant of monitor (there are plenty of slight variations). I don't think I did anything with that in the end.
 

sukhbir

Active member
Feedback
46 (100%)
Credits
1,733CR
is the video rolling up or is the video tearing diagonally?if its rolling up you might have a worn v-hold pot on your monitor or leaky electrolytic caps in the sync correction circuit.
 
Top