Tempest pcb

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
I have a spare tempest pcb which was working but now seems to play blind. As there is no avg chip on these sets not sure where to look. Game start buttons flash as they should and game seems to play fine just no picture output. Monitor works fine with another pcb set.

Where shall I start to look?

Thanks
 

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
Ok thanks. As I don't have spares like that maybe I will get some and try piggybacking.

Could there be the slightest chance that re socketing and chips might resolve it?
 

Equites

Chief Sheesher®
vacBacker
Feedback
35 (100%)
Credits
3,329CR
bonehead said:
Ok thanks. As I don't have spares like that maybe I will get some and try piggybacking.

Could there be the slightest chance that re socketing and chips might resolve it?

I doubt it as game is running, so nothing to do with ROMs or CPU.

Have you tried TEST mode?
 

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
Yes and no faults detected. Will try again later.

Maybe it's time for me to buy a few spare chips and dacs for when things fail.
 

Monstermug

Active member
Feedback
23 (100%)
Credits
1,807CR
Sometimes a broken pot can cause no picture to output out to the screen. If they haven't been changed before then they should be the ones on three legs. Check if the legs are connected to the board properly. Worth a try.
 

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
Well after another look and a test of the pcb and would you believe it!!!! One of the pots on the pcb edge has a broken leg. Bent it over while pcb was powered and now have a perfect working spare pcb.!!!!!!!

Thanks for the help and a massive thanks to Lee for suggesting checking the pots.

Your a star!!!!!!!!

Need to sort this cab trade out also. Maybe next week.
 

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
Just checked the pcb and it's the Y size pot that has a broken leg which is the left hand pot nearest the edge connector. Can't believe how such a small fault could stop the whole pcb from showing a picture but this must have been why the spot killer was lit due to no Y signal monitor.
 

RGP

Meeter & Greeter
Feedback
5 (100%)
Credits
2,039CR
bonehead said:
Just checked the pcb and it's the Y size pot that has a broken leg which is the left hand pot nearest the edge connector. Can't believe how such a small fault could stop the whole pcb from showing a picture but this must have been why the spot killer was lit due to no Y signal monitor.

Vector monitors require a constant changing voltage on both the X and Y inputs to satisfy the rules of the spot killer.

I see a lot of Battlezone boards that power up and run fine on the scope - so long as you adjust the volts/div to about 0.5 or something like that as there isn't enough voltage.

Generally speaking about +/-8-10v is required.

So without the Y pot in the circuit, probably very little voltage going out of the Y pin hence nothing on the monitor.
 
Top