alien vs predator cps2

griffo83x

Active member
Feedback
30 (100%)
Credits
742CR
just powered up my phoenixed avp and was working fine

went into the options to turn the demo sounds on, when i pressed p1+p2 to exit it locked up

turned power off and back on.and is dead as dodo
smiley19.gif


any ideas anybody
smiley5.gif
smiley20.gif


THANKS
 

VectorGlow

Active member
vacBacker
Feedback
34 (100%)
Credits
900CR
Try reseating the program code chips and the PALs.

Failing that, either a program code EPROM has failed, or a logic chip or a PAL.

Could also be a bad contact on one of the pins on one of the board connectors.
 

pulstar

Active member
Feedback
41 (100%)
Credits
459CR
Alpha1 said:
Reseat the A and B boards

This happened to me on my SFA board - was playing and it just locked up and didn't work again, even on other mobos. Other games worked fine on the mobo but the game didn't. There was something in the connector. Cleaned it out and then it worked fine again.
 

griffo83x

Active member
Feedback
30 (100%)
Credits
742CR
VectorGlow said:
Try reseating the program code chips and the PALs.

Failing that, either a program code EPROM has failed, or a logic chip or a PAL.

Could also be a bad contact on one of the pins on one of the board connectors.

cheers phil, i tried reaseating everything but made no difference, looks like another in the pile for you to look at
smiley2.gif

griffo83x2014-03-07 18:28:19
 

VectorGlow

Active member
vacBacker
Feedback
34 (100%)
Credits
900CR
No worries, but silverfox makes a good point - with the power off try shorting out all three pins of EXC1 (marked on the rear of the PCB). I would hope it isn't that but it's worth a try.
 

griffo83x

Active member
Feedback
30 (100%)
Credits
742CR
VectorGlow said:
No worries, but silverfox makes a good point - with the power off try shorting out all three pins of EXC1 (marked on the rear of the PCB). I would hope it isn't that but it's worth a try.

ok , how do i do that
smiley5.gif
 

VectorGlow

Active member
vacBacker
Feedback
34 (100%)
Credits
900CR
Colour variance - can't beat it!
smiley2.gif


You don't have access to an EPROM programmer do you? Would be worth checking out the program code EPROMs.
 

AeroCityMayor

Entity formerly known as alien_mame
Credits
100CR
griffo83x said:
VectorGlow said:
No worries, but silverfox makes a good point - with the power off try shorting out all three pins of EXC1 (marked on the rear of the PCB). I would hope it isn't that but it's worth a try.

ok , how do i do that
smiley5.gif

It's EXC3 above the PAL section and I use a packet of polo mints.

HTH

Cheers,

Ralph.

AeroCityMayor2014-03-10 23:13:23
 
Top